09-04-2024 11:13 AM
I am having some trouble with a new Firepower 1010 that was delivered with 7.2.5 running on it. I was having a few problems with a port not passing traffic when set to auto-negotiate, but we defaulted the device as a troubleshooting step and can now no longer access the web GUI.
I've followed this https://community.cisco.com.mcas-gov.us/t5/network-management/can-t-connect-to-web-configuration-for-firepower-1010/td-p/5055589 without success.
I ran through the running-config and the only noticeable difference I can see is 'http server enable' missing - as seen from a known good device. I've searched multiple sites and cannot figure out how to enable that, or if that is truly the problem. I've attached a screenshot of the error we're seeing and the CLI output.
Thank you for the help
09-05-2024 12:23 AM
- Could you add those directives from 'working appliance.txt' too in the running configuration of the
problematic firepower device(?)
M.
09-05-2024 03:06 AM
I did try that but they don't seem to be valid commands. I haven't been able to question mark my way through it yet, do you know how to do this?
09-05-2024 12:27 AM
Manage the device locally? (yes/no) [yes]: Yes
did you select device mgmt locally ?
MHM
09-05-2024 03:07 AM
Yep, I followed your directions from another post to make sure everything was set correctly.
09-05-2024 03:13 AM
Hello dbronco,
Please follow the link..you can find similar kind of discussion....
Best regards
******* If This Helps, Please Rate *******
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide