Firepower 1010 - FDM: unable to upload a file with IP address for Blacklisting
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-11-2019 04:54 AM - edited 02-21-2020 09:45 AM
Hi guys,
I have an issue with a Firepower 1010 (running 6.5) and the FDM.
I have a long list with public IP addresses (one address per line) and need to create a Blacklist in the FDM (FMC cannot be used there).
When I go in FDM under Policies > Security Intelligence > Network > Blacklist (Block/Drop) I don't see a possibility to upload this file :-( (See attached)
Also under Objects > Networks just can create normal Host- or Group-Objects but there is no possibility to upload a file with IP addresses. I don't want to enter all the IP addresses as Host-Objects ...
I checked the FDM guide but I did not find a hint that a ASCII-file upload with IP addresses is possible as in the FMC.
Do you know if it is possible to upload a ASCII-File with IP addresses for Blacklisting or do I try something impossible?
Thanks a lot for every hint!
Bye
R.
- Labels:
-
NGFW Firewalls
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-11-2019 08:04 AM
You are correct, custom SI feeds is apparently only available when using FMC. On FDM the only options appear to be the TALOS feeds or manually defined objects.
