cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
273
Views
2
Helpful
1
Replies

Firepower 1010 with ASA - Security plus license warning

Chess Norris
Level 4
Level 4

Hello,

A customer just got an insufficient license warning in the smart license portal. They have a single Firepower 1010 appliance that run ASA code.

I'm trying to figure out the reason why they receive this warning.

On the old ASA 5505 I remember there was quite a few limitations without a security plus license, for example you could maximum use 3 VLANs, but I dont belive the same limitations exist on the 1010.

From the information I could find about the security plus license on 1010, is that it's required for failover and that is a feature the customer dont use.

Thanks

/Chess

1 Reply 1

nspasov
Cisco Employee
Cisco Employee

The security plus license for the 1010 is only required if the customer needs to configure and run High Availability. I suspect they are getting the warning due to someone activating the license. E.g., via CLI:
ciscoasa(config-smart-lic)# feature security-plus

Thank you for rating helpful posts!

Thank you for rating helpful posts!
Review Cisco Networking for a $25 gift card