07-29-2024 12:24 PM
Hello All,
I'm trying to configure firepower 3140 (2 FTD ) in a cluster using FMc 4600 and have the following:
- For CCL I have port-channel configured (2 ports) on each unit, MTU 9098 and status is up.
- When adding the cluster the port-channel does not appear under the interface (CCL) drop down list.
Any ideas?
Thanks
07-29-2024 05:00 PM - edited 07-29-2024 07:03 PM
did you make sure the etherchannel is unnamed and you have not set any ip etc ?
Please provide a screenshot of the etherchannel and cluster config dropdown for interface ?
07-30-2024 08:19 AM
Hi,
That exactly what I did, I removed the name and it showed up under the interfaces list.
Thank you
07-30-2024 12:36 PM
Great to hear that worked
**Please mark as helpful and solution if this was useful**
07-30-2024 09:40 AM
Make sure the port-channel for the Cluster Control Link (CCL) on Firepower 3140 is unnamed and without an IP address. This will allow it to appear in the interface dropdown list during FMC 4600 cluster configuration.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide