Firepower: How to use API
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-08-2024 06:13 AM
Hello,
I wish to access the API of Firepower2140 to make backups via an open-source application.
Is the API feature enabled by default to run curl requests?
Also, is there a URL to list all possible API requests?
Best Regards,
José

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-08-2024 06:29 AM
@jds5 you can find this here https://developer.cisco.com/docs/ftd-api-reference/latest/ and example with curl here https://www.cisco.com/c/en/us/td/docs/security/firepower/ftd-api/guide/ftd-rest-api/ftd-api-methods.html
Hope this helps.
Connect with me https://bigevilbeard.github.io
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-08-2024 06:31 AM
- You may start here : https://www.cisco.com/c/en/us/td/docs/security/firepower/630/api/REST/Firepower_Management_Center_REST_API_Quick_Start_Guide_630/About_the_Firepower_REST_API.html
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-09-2024 12:37 AM
The API should be enabled by default on the FMC/FTD device.
To view a list a possible API calls you can browse to https://<deviceIP>/api/api-explorer
Please remember to select a correct answer and rate helpful posts
