03-03-2022 02:41 PM
Hi have version 6.6.5.1 running on a 4115 and a 2130.
The copy capture: command is no longer working.
Here is the capture in memory.
> show capture
capture testpc type raw-data interface inside [Buffer Full - 524225 bytes]
match ip host 10.180.122.12 any
This command is not able to get the capture into a file.
copy /pcap capture:
Syntax error: The command is not completed
It does not matter what you type after capture: the command will not complete.
Pressing spacebar at the end of the follow does nothing.
copy /pcap capture:testpc
On an ASA missing items will be prompted for.
> copy /pcap capture: disk0:
Source capture name []?
?Bad filename
%Error parsing filename (No such device)
On the FTD the prompt does not wait for input, spits out the error messages and back to the prompt.
Solved! Go to Solution.
03-03-2022 11:52 PM
@Garry Cross what about if you login to the diagnostics CLI - "system support diagnostic-cli" and perform the same command?
03-03-2022 11:52 PM
@Garry Cross what about if you login to the diagnostics CLI - "system support diagnostic-cli" and perform the same command?
03-04-2022 06:51 AM
Thank you Rob. I forgot about that access to the cli.
> system support diagnostic-cli
hostname> enable
Password:
hostname#
hostname# copy /pcap capture:testpc ?
cluster: Copy to cluster: file system
disk0: Copy to disk0: file system
flash: Copy to flash: file system
ftp: Copy to ftp: file system
scp: Copy to scp: file system
smb: Copy to smb: file system
tftp: Copy to tftp: file system
hostname# copy /pcap capture:testpc flash:testpc.pcap
Source capture name [testpc]?
Destination filename [testpc.pcap]?
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
1249 packets copied in 0.40 secs
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide