Hi; I have two FMC 2500 on HA; planning upgrade from 6.4.0-13 to 6.6.1-91.
My process:
1 backup.
2 check ntp and space on disk.
3 upload file on active and standby
4 pause HA synchronization
5 run readiness on both devices, active and standby
6 update standby
7 update active
8 re sync HA
But, when I run readiness on active and standby; active run ok; but standby never start the process and don't generate task about this.
Any suggestion to validate? or command to run on expert mode?
Can I proceed to upgrade without run readiness evaluation?