Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I try to implement HSRP + BDF over 400 BVI at ASR9K, I need to know if exist a best practice about configure HSRP and BDF.I found this link: https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/ip-addresses/command/reference/b-ip-addresses-...
Hi Community, I need to enable a connection by STM-1Channelized to map E1s from pseudowires with this hardware.
ASR 9010RSP800 - XR 7.5.2 / 7.9.21A9K-48X10GE-1G-SE or A9K-24X10GE-1G-SESmart SFP - SFP-CH-OC3STM1-I
https://tmgmatrix.cisco.com/?si=SFP-C...
Hi community, I'm working on implementing EEM on a Cisco ASR9K; I need to be able to determine by syslog when a track changes UP/DOWN status. When I add the lines of "event manager environment" the system only leaves the last one of "environment". I ...
Hi Community, I'm trying to install DNAC on appliance DN2-HW-APL with reference the "Cisco DNA Center Second-Generation Appliance Installation Guide, Release 2.1.2".
https://www.cisco.com/c/en/us/td/docs/cloud-systems-management/network-automation-an...
Hi, anyone how can help to me and validate or recommend a topology to implemente a cluster of CNR for DHCP on failover pair; using a second Nic to that redundancy service?
Topology one:
It's posible implement a failover-pair if de IP address on seco...
Hi Marvin, the version 6.6.1 because the minimum release to integrate some new devices, but you are right 6.6.7 is a better option to upgrade; and in this moment 7.0.4 can wait because we have another device on 6.2.3 but need to do other priorities n...
Hi BB; thank you by your suppport, I did a Lab of upgrade.
Lab 1: FMC 6.4.0.13-57 >>> 6.6.0-90; successful.
Lab 2: FMC 6.4.0.13-57 >>> 6.6.1-91, successful.
I'm goning to go by the LAB2 on real environment.
Thanks a lot.
Hi Andrea, thank you for your support.
Yes I was saw the doc Nexus 9000 TCAM Carving before as reference in other post. I decide get out 512 of RACL to set later at PACL, I used 512 to PACL because is de default value on Nexus 93120.
The confi...
