05-16-2019 04:20 AM - edited 02-21-2020 09:08 AM
FMC is not showing any event and logging connection, I've configured everything as below
Information
-FMC1000-K9 Version 6.3.0.3
-FTD2110 Version 6.3.0.3
05-16-2019 05:09 AM
Are you seeing no connection events at all (under Analysis > Connections)?
05-16-2019 06:08 AM
05-16-2019 06:13 AM
05-16-2019 06:50 AM
Your policy setup seems to be correct as far as what you shared already.
The sftunnel process that connects the sensor to FMC may be hung.
It would be best to open a TAC case and they can do some quick checks from the cli to verify and confirm that communications are established properly.
05-16-2019 08:03 AM
To Marvin
Thx for support. I will take your advice....Have you ever had that problem?
05-16-2019 07:33 PM
Yes I have seen it before. The cause may vary but one thing to check is as follows below (from the FMC cli). Interpretation of the output is not immediately obvious so that is why I recommend a TAC case to assist.
Get the Current Process status:
Restart all the processes:
Get the Processes status again:
05-17-2019 03:38 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide