05-29-2024 08:45 PM
Hi Guys:
I am configure our first FMC 1700 chassis now, and trying to enable the CIMC interface
FMC management interface is configured and reachable. I went to System > Configuration > Console configuration > light Out Management, then try to configure a static IP address (different subnet from management interface)
but received error :
The ip address needs to be on same subnet as the management IP address.
we do have other Cisco appliance like Prime deployed and CIMC always in different subnet with management interface
Does FMC CIMC interface has to be in the same subnet as MGMT? or there is some configure I missed?
Cheers
Jason
Solved! Go to Solution.
05-30-2024 05:36 AM
Configure a static CIMC address using the CIMC configuration option which can be accessed at boot time from a directly attached keyboard and monitor.
05-30-2024 05:36 AM
Configure a static CIMC address using the CIMC configuration option which can be accessed at boot time from a directly attached keyboard and monitor.
05-30-2024 03:20 PM
Hi Marvin
Thank you for the info and it helped but didn't resolve my problem
I managed to rebooted the FMC 1700 and press F8 to enter the CIMC configure page, the funny thing is, keyboard up/down is working which proved keyboard is fine, but I was unable to use "enter" to enable/disable any options. and I do have DHCP enabled and received a dynamic IP (reachable and accessable), but I would like to change to static and unable to
05-30-2024 03:36 PM
my bad, it is "space" rather than "enter"
all sorted now, Thank you Marvin
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide