cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
146
Views
0
Helpful
2
Replies

FPR 1120 - Traffic to/from the Inside interface to other interfaces

john.garza
Beginner
Beginner

We have an FPR 1120 that we're configuring and we have a Wireless LAN controller on the inside interface that WiFi APs will need to connect to from the other FPR interfaces; i.e. 1/3, 1/4, etc.  On our existing ASA 5506-X I think we used a command that allowed traffic between interfaces, it was something about the same security level ??  Is there a similar command on the FPR to allow traffic between interfaces ?

2 Replies 2

Rob Ingram
VIP Expert VIP Expert
VIP Expert

@john.garza you are referring to the ASA command "same-security-traffic permit inter-interface" this is enabled as default on the FTD, you just need to permit the traffic in the Access Control Policy.

Sheraz.Salim
VIP Advisor VIP Advisor
VIP Advisor

are you running the ASA code on FTD unit give command 'same-security-traffic permit inter-interface'

 

Unlike with classic ASA software, Firepower Threat Defense by default allows same-security traffic both inter- and intra-interface.

please do not forget to rate.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers