ftd cli showing data in bytes/sec change to GB/s ?

[Wonxie]

Hi,

I have noticed that fmc ui (in analaysis ) e.g. checking elephant flows shows data in bytes..

similarly many command that i need in ftd cli give output in bytes and bytes per sec .. e.g show traffic etc 

Is there any possibility to change them to some more readable format like mb/s or gb/s ?

Regards.

[Marius Gunnerud]

It is not possible to change the output from bytes to anything else on the CLI.  Also, as far as I know it is not possible to change the output in the GUI.

The best way to get around this is to send SNMP, Netflow logs to an external monitoring server.

[MHM Cisco World]

from CLI you can not change the rate from bytes/s to GB/s

but since you mention elephant flow 

there is feature in FMC you run to detect any flow above specific rate 
Cisco Secure Firewall Release 7.2 - Elephant Flows - YouTube

MHM