Hi I have an access control rule that permits traffic from server to another server via tcp/5000 and an intrusion policy is applied to this rule.there is one intrusion rule hitting where the rule definition has in the destination ports different port...

hii have cisco 6500 series core switch and facing a bizarre issue with data speed transfer.I have two vlans svi for which is defined on this switch (core6500). these vlans are transported to another switch (sw5) via lacp etherchannel which is providi...

Hi,I have noticed that fmc ui (in analaysis ) e.g. checking elephant flows shows data in bytes..similarly many command that i need in ftd cli give output in bytes and bytes per sec .. e.g show traffic etc   Is there any possibility to change them to ...

Hi,I have a core switch 6509 on core. It has many SVI for intervlan routing. we have defined a vlan on it for guest (vlan id 202)  with no svi defined on it. A port in access mode in vlan202 is connected to a separate ISP ONT for internet connectivit...