08-28-2020 01:47 AM - edited 08-28-2020 01:48 AM
FTD setup through both cli & FMC
Interface 1 conf:
5 sub-interfaces, each interface is VLAN ID + SubintID = 10,20,30,40,50
IP: 192.168.10.10, 192.168.20.10 etc
SW Setup CLI:
Interface 9:
Switchport mode trunk
switchport trunk allowed vlan 10,20,30,40,50
Interface 1 - 5: (each interface got 1 VLAN added. int 1 = VLAN10, int 2 = VLAN20 and so on)
Switchport mode access
Switchport access vlan 10
VLAN 10,20,30,40,50:
Got the same IP as the Sub-ints on the FW
---------------------------------------------------------------
Interfaces & VLANs are up, but cant ping from either device.
On FTD I have enabled ICMP & made ACLs totally open but no success.
This is the end idea:
Host -> VLANx/interfacex -> interface9 (trunkport) -> FTD -> FTD inspects packets & route it back to source host
What have I missed to conf or done wrong?
Any suggestions would be great
Also check attached for diagram.
Solved! Go to Solution.
08-28-2020 05:47 AM
Just realized the FTD havent commited my changes of the sub-ints as its not licensed yet...closing discussion.
08-28-2020 05:47 AM
Just realized the FTD havent commited my changes of the sub-ints as its not licensed yet...closing discussion.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide