12-11-2011 07:25 PM - edited 03-11-2019 03:01 PM
Hi All,
I am trying to remove a line in a particular access-list configured in a FWSM module using this command "no access-list <acl> line 19 x x x x" but it doesn't work. See below:
FWSM/xxx03(config)# no access-list ?
configure mode commands/options:
alert-interval Specify the alert interval for generating syslog message
106001 which alerts that the system has reached a deny
flow maximum. If not specified, the default value is 300 sec
deny-flow-max Specify the maximum number of concurrent deny flows that can
be created. If not specified, the default value is 4096
How can I remove a line from the access-list without clearing the entire access-list?
Thanks in advance
12-12-2011 07:48 AM
You can remove one line instead of invisibility of this option. Type "no" and ACL entry which you want to delete.
12-12-2011 02:58 PM
Thanks Andrey.
You mean I should just type
" No access-list
and it will work?
But why doesn't the IOS show it?
12-12-2011 04:10 PM
Hello Nirmal,
What Andrey suggested is correct, that is all you need.
Now on the last post you add it this:
No access-list
Everything is fine except the extended. you do not need that, so it would look like this example:
No access-list test permit tcp any any eq 80
That should take out from the access-list that particular line, now it is weard that when you do no access-list you do not get the word command ( witch is the name or number of the ACL) but lets give it a try with the command Andrey suggested and let see how it goes.
Please rate helpful posts.
Julio!!!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide