Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Currently, I have Layer 3 routed links between a pair of Cisco 6513 switches and a pair of Nexus 7k switches (see diagram below). The Nexus and 6513 are running BGP between them, and iBGP among themselves (Nexus and Nexus, 6513 and 6513).Recently,...
Hi All,My client Core Switch has mls qos enabled globally, and I've also configured couple of interfaces with "mls qos trust dscp" . When I check the output of those interfaces, it says that the Trust level is No. Why is that so? Would it trust any p...
Hi All,I've recently received this new Cisco 1921 routers with Cisco CP loaded, so it comes up with the annoying change username and password at first access. I've removed all of those files from the flash memory, and rebooted it, and it came up with...
Hi All,I having some doubts on whether QoS will be applied to egress traffic. Here's my scenarioVoice GW --->Core Sw-->WAN provider routerIf calls are coming through to the Voice GW to say a Lync client, the traffic will be marked as dscp ef on the V...
Hi All,I am working with a client to implement QoS for their Lync environment. Lync 2010 has this feature to mark dscp values based on packets tagged with logical ports. As an example, packets on port 49000 til 49999 will be marked to dscp 46(ef). On...
Yes, a downtime is scheduled for this. Is there going to be any interruption to the load balancing algorithm if I change it from it's default src-dest-mac to src-dest-ip? There are currently many port channels formed on the 6513 switches to other swi...
Same stuff, but I do have another router that's working fine when I do a sh run.Problematic router:xxxxxx#sh hardwareCisco IOS Software, C1900 Software (C1900-UNIVERSALK9-M), Version 15.1(4)M4, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisc...
Thanks Nik. I'll do that.The other things is that the Lync client is connected to a switch, and then to a router. I am only doing QoS on the router and not on the switch. Do I need to set anything on the switch to honour the dscp markings based on po...
