Hi,
My customer recently decided to switch from Cisco to Palo Alto as perimeter firewall solution. The design decision was to keep the same security policies and this implies PA provider needs the backup of existing ACPs in our Firepower solution.
In our case, Firepower is installed as an ASA module and the ASA configurations (NAT rules, VPN, everything visible through ASDM) have been translated to the new firewall by the PA engineer. However, this hasn't been possible with our ACP deployed in FMC. I can't find some command like "show run" in the FMC nor FirePOWER modules; we tried to read some ACP configuration from backup and troubleshooting files, but PA engineer says that's not what he needs.
Is there, then, any other way to extract the ACPs in a plain-text format?
Thanks.