09-04-2008 07:51 AM - edited 03-11-2019 06:39 AM
What is the way to get the arp table on an ASA using snmp? I tried doing an snmp walk on .1.3.6.1.2.1.4.22, which works on a Cisco router, but got nothing.
Thanks
Mike
09-10-2008 08:41 AM
To view the ARP table, use the show arp command in privileged EXEC mode.The display output shows dynamic, static, and proxy ARP entries. Dynamic ARP entries include the age of the ARP entry in seconds. Static ARP entries include a dash (-) instead of the age, and proxy ARP entries state "alias."
09-10-2008 09:21 AM
what you are trying to accomplish in the ASA is not supported.
You already has configured SNMP on the ASA but it seems that there is no MIB that supports
to extract the ARP table and send it to that tool.
Here you have the link with the SNMP configuration and also there is a section that
indicates all the MIB supported, unfortunately there is nothing to obtain the ARP table.
http://www.cisco.com/warp/public/110/pixsnmp.html
there is nothing supported in version 7.x either, Checked the MIB
but nothin related with that.
http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chap
ter09186a0080565912.html
Please rate if helpful.
Regards,
Sushil
09-10-2008 09:25 AM
I was afraid of that. :) Thanks anyway.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide