Healt monitor FMC not FTD graphics

[Translator]

Hello Good afternoon I'd like to see if you can help me with a consultation we currently have an FMC that manages 4 FTD all in version 7.0.5, when you enter the healt monitor option this shows well the health graphics associated with the FMC but the health graphics of the other 4 Firewall do not plot anything just show the message of "No Data Available" check the polite of the healt monitor and the modus monitoring is all enabled and correctly applied to devices but graphics still show nothing, follow the procedure to enable this monitoring but still I don't want to be grateful if you could help me with some information on what the problem might be

[Translator]

Hello Kristian,

I share a couple of links that can help you, check them out and tell us:

https://community.cisco.com/t5/network-security/fmc-dashboard-stopped-showing-data/td-p/2962648

https://www.grandmetric.com/troubleshoot-fmc-firepower-sensor-communication/

Greetings,

[Translator]

Hello @Julio E. Moisa it's always a pleasure to read you, you were missed in the community. We hope you're all welcome

@kristianrgc we wait for information to be helpful 

[Translator · Accepted solution]

I thank you very much for your time and response finally the problem was due to a bug, which was climbed to cisco

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCwd30296

when doing work around with TAC support the problem was solved

thank you very much.