I've been trying to configure CSM 3.1 to manage an IPS module (AIP-SSM) in an ASA 5510. I can add the ASA, which is running V8 software, to the CSM and push policies etc without problem. But I cannot figure out how to add the IPS module into CSM. When I load the ASA config into CSM it dosent see the IPS module, question is should it learn about it automatically or do I add the IPS as a seperate module.
I'm not 100% sure the IPS module is functioning correctly, although I can connect to the AIP-SSM using the session command on the ASA, I'm unable to access it either by ASDM or telnet over its managment address.
I'm not sure of the procedure I should follow to get the IPS into CSM?