11-26-2021 03:47 AM
Hi Folks,
I have a situation where I need to change my standby firewalls MGMT interface IP via Primary one.
My secondary is up but not reachable for SSH due to service providers IP conflict.
1. Is it possible to do so ? or shall I need to arrange an engineer to visit data center and take console only.
2. What are the parameters we need to consider while changing the interface IP.
Solved! Go to Solution.
11-26-2021 04:29 AM
If that the Interface used for HA, then suggest to shutdown on Switch side port, due to conflict, send some one over DC and change the IP and reboot ASA, enable port to check the HA status, this is the best.
11-26-2021 04:29 AM
If that the Interface used for HA, then suggest to shutdown on Switch side port, due to conflict, send some one over DC and change the IP and reboot ASA, enable port to check the HA status, this is the best.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: