11-14-2019 04:09 AM
What command do i use to check if a vpn address pool is full?
Solved! Go to Solution.
11-14-2019 12:28 PM
if you are asking for the anyconnect vpn address pool than you use this command
show ip local pool ?
ASA# show ip local pool anyconnect
Begin End Mask Free Held In use
192.168.101.1 192.168.101.10 255.255.255.0 10 0 0
Available Addresses:
192.168.101.1
192.168.101.2
192.168.101.3
192.168.101.4
192.168.101.5
192.168.101.6
192.168.101.7
192.168.101.8
192.168.101.9
192.168.101.10
11-14-2019 12:28 PM
if you are asking for the anyconnect vpn address pool than you use this command
show ip local pool ?
ASA# show ip local pool anyconnect
Begin End Mask Free Held In use
192.168.101.1 192.168.101.10 255.255.255.0 10 0 0
Available Addresses:
192.168.101.1
192.168.101.2
192.168.101.3
192.168.101.4
192.168.101.5
192.168.101.6
192.168.101.7
192.168.101.8
192.168.101.9
192.168.101.10
11-16-2019 11:27 AM
Thank you.I did manage to figure it out after doing some diggibg with the config.Thanks!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide