03-08-2010 06:07 AM - edited 03-10-2019 04:54 AM
Hi,
I got a AIP SSM-20 for asa 5520.I am very new to this product.I have gone through few documents and understood how to redirect traffic from ASA to AIP-SSM.
I dont have clear idea on
1) How to access AIP-SSM through ASDM.
2) Is it possible to assign an ip to AIP-SSM from my inside interface LAN.
3) Is it required connect to management interface of the AIP-SSM to any switch(LAN).
4)How to control(Allow or Block) traffic.Since i am not very familiar with IDS/IPS , i want allow all the traffic but capture the logs of the aatck.
Can you take me through(Links to the documention site) step by step configuration which would place IDS/IPS in my network.
Thanks in advance.
03-11-2010 05:59 AM
Hi Uthay,
Plz find our response below.
1) How to access AIP-SSM through ASDM.
2) Is it possible to assign an ip to AIP-SSM from my inside interface LAN.
3) Is it required connect to management interface of the AIP-SSM to any switch(LAN).
4)How to control(Allow or Block) traffic.Since i am not very familiar with IDS/IPS , i want allow all the traffic but capture the logs of the aatck.
Can you take me through(Links to the documention site) step by step configuration which would place IDS/IPS in my network.
* TOP ATTACKER REPORT
* TOP VICTIM REPORT
* TOP SIGNATURE REPORT & More.
Let us know the update once you had configured. Good luck
11-15-2013 07:08 PM
Hi ycs chennai,
i want allow all the traffic but capture the logs of the attack but can i do this configure through GUI?
i am not familar with ids CLI...i want all traffic only in detect mode...
suhas B
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide