10-14-2021 05:21 AM
How to see MAC Table in FPR 1010 CLI or GUI ? I ran below commands and does not show any MAC.
> show mac-address-table
> show mac-learn
no mac-learn flood
interface mac learn
-------------------------------------------
Inside enabled
Outside enabled
diagnostic enabled
Solved! Go to Solution.
10-14-2021 01:57 PM
Hi @MSJ1,
Assuming that you are really looking into looking at MAC address table (as FPR1010 has 8-port switch), you can use show switch mac-address-table.
As FPR1010 usually gets deployed as routed FW, you would most likely be more interested in show arp in order to see neighbouring devices.
BR,
Milos
10-14-2021 01:57 PM
Hi @MSJ1,
Assuming that you are really looking into looking at MAC address table (as FPR1010 has 8-port switch), you can use show switch mac-address-table.
As FPR1010 usually gets deployed as routed FW, you would most likely be more interested in show arp in order to see neighbouring devices.
BR,
Milos
10-14-2021 06:36 PM
Thank You very much @Milos_Jovanovic
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide