How to see MAC Table in FPR 1010 CLI or GUI

[MSJ1]

How to see MAC Table in FPR 1010 CLI or GUI ? I ran below commands and does not show any MAC.

> show mac-address-table

> show mac-learn
no mac-learn flood
interface mac learn
-------------------------------------------
Inside enabled
Outside enabled
diagnostic enabled

[Milos_Jovanovic · Accepted solution]

Hi @MSJ1,

Assuming that you are really looking into looking at MAC address table (as FPR1010 has 8-port switch), you can use show switch mac-address-table.

As FPR1010 usually gets deployed as routed FW, you would most likely be more interested in show arp in order to see neighbouring devices.

BR,

Milos

[MSJ1]

Thank You very much @Milos_Jovanovic