How to Setup Cisco ASA High Availability !

[Mohamed Sadek Ben Hlel]

Hello,

How to setup HA between two cisco asa 5512 with firepower module

and is it possibl to configure HA if have an interfaces WAN1 that use PPPoE

[ankojha · Accepted solution]

Hi,

For failover /HA configuration of ASA you can refer the below document :

http://www.cisco.com/c/en/us/td/docs/security/asa/asa91/configuration/general/asa_91_general_config/ha_failover.html

Firepower setup and installation has to be done separately on both the boxes independent of the ASA in failover mode.

For interfaces that use PPPoE query, the below document says PPPoE is not supported in HA mode:

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/110322-asa-pppoe-00.html

Rate if it helps.

Thanks,

Ankita

[Mohamed Sadek Ben Hlel]

Thank you

[ankojha]

Hi Mohamed,

You can also mark the answer as correct if it helped in resolving your query.

Have a nice day ahead.

Thanks,

Ankita

[vaibhav58]

Hi Ankita,

How can I configure 2 ASA with firepower in HA .

Need to use both ISP simultaneously, ex- Internet traffic through one and rest services through other.

Would Active -Passive Configuration do? How can it be designed?

TIA!!

Regards

Vaibhav