09-17-2021 12:26 AM
I booted the ISE and press F8 to setup CIMC basic configuration like below.
IP(Basic)
IPv4 [×]
DCHP enabled: []
CIMC IP: 10.10.10.100
Subnet: 255.255.255.0
Gateway: 10.10.10.254
Pref DNS Server: 0.0.0.0
VLAN (Advanced)
VLAN enabled: [×]
VLAN ID : 10
Priority:0
After that, I had my pc directly connected into the CIMC management port(dedicated port) of ISE using LAN cable. Then, I entered 10.10.10.100 on GooleChrome. however, there is no response.
I wanna enter the CIMC page.
How could I solve this ?
My pc address is 10.10.10.2/24
I need your help.
Solved! Go to Solution.
09-17-2021 12:52 AM
You configured CIMC to use a tagged connection. With that, you typically can't directly connect a PC if it is not also configured for tagging.
I would remove the VLAN-config and place the CIMC directly to an Access-Port in you appropriate management-VLAN.
09-17-2021 12:52 AM
You configured CIMC to use a tagged connection. With that, you typically can't directly connect a PC if it is not also configured for tagging.
I would remove the VLAN-config and place the CIMC directly to an Access-Port in you appropriate management-VLAN.
09-17-2021 01:11 AM
thank you for big help
I got it!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide