How to Setup ISE CIMC

[naoki_Japan]

I booted the ISE and press F8 to setup CIMC basic configuration like below.

IP(Basic)

IPv4 [×]

DCHP enabled: []

CIMC IP: 10.10.10.100

Subnet: 255.255.255.0

Gateway: 10.10.10.254

Pref DNS Server: 0.0.0.0

VLAN (Advanced)

VLAN enabled: [×]

VLAN ID : 10

Priority:0

After that, I had my pc directly connected into the CIMC management port(dedicated port) of ISE using LAN cable. Then, I entered 10.10.10.100 on GooleChrome. however, there is no response.
I wanna enter the CIMC page.

How could I solve this ?

My pc address is 10.10.10.2/24

I need your help.

[Karsten Iwen · Accepted solution]

You configured CIMC to use a tagged connection. With that, you typically can't directly connect a PC if it is not also configured for tagging.

I would remove the VLAN-config and place the CIMC directly to an Access-Port in you appropriate management-VLAN.

[naoki_Japan]

thank you for big help

I got it!!