I don't want security on a model Valet M10. Can you help?

[georgebaxter]

I don't want over the air WPA OR WPA2 security on my model Valet M10. I have gone through all the choices and did not see a way to disable security. I am way out in the country and there is no one near that could use my wifi and do not want to enter codes into all my devices.

The default configuration of most wireless routers is unsecure, not this one.Please help!

Below is a link to the manual.

http://homedownloads.cisco.com/downloads/userguide/1224655305646/Valet_Valet_Plus_M10_M20_UG_US_V10_D-WEB_3425-01453,0.pdf

[georgebaxter]

Shame on Cisco. I figured it out my self no thanks to Cisco.

I was using the help in the router to help me figure this out. They list all the choices in security except disable. So I did not know it was an option in the drop down. When I did find it, I disabled it and no wireless was available. I went to my wired computer and entered the setup were it then asked me if I knew what I was doing I clicked yes and walla I had open wireless. There was not a word about any of this in the documentation.

So thanks any way!

Mabe this will help someone else!