Network Security

Hi All,I have created the 50 numbers vlan in the switch and ASA.Can i monitor the all Vlan through IPS? Pl reply.

After following procedure on:http://www.cisco.com/en/US/docs/security/ips/6.0/installation/guide/hwImage.html#wp1183593Module becomes UNRESPONSIVE, after hw-module module 1 recover boot command.I'm using IPS-SSM_20-K9-sys-1.1-a-6.1-1-E1.img¿Any idea...

Suppose I am using VPN software client OR PIX Firewall VPN client to establish VPN tunnel with Easy VPN server:-1. In Message 1 the VPN client(software VPN client or PIX VPN client) will initiate Phase-1 prposals(like Encryption algorithm,hash algori...

My Setup consist of:Cisco ASA 5510 v8.0(2)Cisco ASA-SSM10 IPS ver 5.0(2)S152.0Q: I would like to know what is needed to upgrade the IPS to the latest Software version. There is currently no license present in my IPS.Is it possible for me to upgrade f...

dear Team,We are using Clear Xlate command whenever we are adding new Translation rules so that the new rules will get added to Traslation table.Will it mean that the new translation rules will not get added OR get added after some specific configure...

hey folks, I'm seeing a repeated entry, every few minutes, as follows: Fri Jan 02 11:16:14 CST 2009 class com.cisco.nm.cmf.jrm.AuthenticationService :: Clearing UserRoleCacheFri Jan 02 11:16:14 CST 2009 class com.cisco.nm.cmf.jrm.AuthenticationServic...

Hi, I have configured a 877 as a Easy VPN server. When a client connects to the VPN we can only reach the native vlan:VPN clients: 192.168.2.0/24VLAN 1(native): 192.168.1.0/24VLAN 100 (voice): 192.168.100.0/24There must be something wrong in the conf...

1841 router will support easy vpn ?

In case of multicasting it is mentioned that igmp join-group is used when the users(who need access to some multicast group) are not able to send the igmp join messages, then PIX firewall will join to the required multicast group on the behalf of tho...

Hi,We have installed ASA 5505 in Datacenter and configured two zones DMZ and Inside. The App Servers are placed in DMZ and DB Servers are placed in Inside Zone. One unmanagable switch is connected with DMZ interface of FW and the second one with Insi...

One general question-When we access internet using broadband connection from home will it be a kind of IPsec tunnel from my PC to Service Provider network--Why I am asking is because when I connect to Service Provider network i will get an IP address...

Hi All,I have configured the ip address in the IPS 4240,Like x.x.x.201/24,x.x.x.1,When i type the https://x.x.x.201 in the internet explore ,page is not opening.What would be the problem and give the ideaThanks.

Hi Team,I have following question about Nating:-1. static(inside,outside)-Will this command works bidirectionally i.e. Traffic which is coming from outside to inside or reverse both will get NATed OR it only mean that the traffic which is coming from...

Hi Team,As We know that their are 6 steps in Main mode and 3 Steps in Aggressive mode for IKE SA.In Main Mode the steps are:-In Steps 1 & 2 the Initiating peer will send the required Encryption algorithms,Hash algorithm etc over internet to the peer ...