Is no ip nat service sip udp port 5060 a valid cmd?

[eferland]

On

# show ver

Cisco Adaptive Security Appliance Software Version 8.4(3)

Device Manager Version 6.4(7)

Compiled on Fri 06-Jan-12 10:24 by builders

System image file is "disk0:/asa843-k8.bin"

Config file at boot was "startup-config"

FWall up 1 year 33 days

Hardware:   ASA5510, 1024 MB RAM, CPU Pentium 4 Celeron 1600 MHz

Internal ATA Compact Flash, 256MB

BIOS Flash M50FW016 @ 0xfff00000, 2048KB

Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)

                             Boot microcode        : CN1000-MC-BOOT-2.00

                             SSL/IKE microcode     : CNLite-MC-SSLm-PLUS-2.03

                             IPSec microcode       : CNlite-MC-IPSECm-MAIN-2.06

                             Number of accelerators: 1

I keep getting

FWall(config)# no ip nat service sip tcp port 5060
                     ^
ERROR: % Invalid input detected at '^' marker.

[Marcin Latosiewicz · Accepted solution]

Eric,

This is a command to disable NAT ALG for SIP on IOS routers.

On ASA you can do similar by removing SIP protocol inspection.

If in doubt check the command references, both ASA and IOS versions are available online.

M.