is this flow impossible?

[JunSungKim2765]

hi

I want to connect to M1/1 through inside2 and inside.

how can i make it?

thank you

best regards

[MHM Cisco World]

Why you not interconnect both L3 device instead of this?

MHM

[JunSungKim2765]

thank you for a reply.

We need a security policy when the traffic goes to inside from insdie2.

best regards

[MHM Cisco World]

L3 is router or SW

MHM

[Kasun Bandara]

@JunSungKim2765 can you elaborate more about your requirement? what is the use case. if you are looking to manage ASA via ASDM, you can set 'management interface' settings. and is your inside and management in same subnet or different subnets?

[JunSungKim2765]

thank you for a reply.

inside, management, and inside2 are in different subnet.

If i do telnet to M1/1, the traffic drops.
Because ASA forwards inside2 traffics to MGMT interface directly.
even though I set for a example, 'route inside 192.168.1.0/24(MGMT) 10.10.10.2.

best regards

[MHM Cisco World · Accepted solution]

Config inside 1 OR inside 2 as managment-access

MHM

[JunSungKim2765]

thank you for a reply.

it works. but I don't know why.

I'm reading about management-access feature.

best regards