Hi,
New to ASA. Basic question, how can I list the physical interfaces for a redundant interface? I tried the following.
ASA version is Cisco Adaptive Security Appliance Software Version 9.6(1)
show interface summ
Interface GigabitEthernet1/1
<snip>
Interface Management1/1
<snip>
Interface Redundant1.400
<snip>
show interface redundant 1 detail
Interface Redundant1.400 "inside", is up, line protocol is up
Description: -ServerAdminBand-
MAC address cc16.7e86.88cc, MTU 1500
IP address 172.16.21.81, subnet mask 255.255.255.240
Traffic Statistics for "inside":
27869737 packets input, 2162299556 bytes
6470207 packets output, 3732215263 bytes
20957467 packets dropped
Control Point Interface States:
Interface number is 3
Interface config status is active
Interface state is active
Control Point Vlan400 States:
Interface vlan config status is active
Interface vlan state is UP
Thanks for any help.