Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Having issues with my VPN configuration.  I have a couple of servers on prem and a couple in Azure.  It worked fine until I added the following commands:access-list TIMECARD_WS standard permit 5.5.5.5 object network vpntestsubnet 192.168.0.230-192.16...

cjones615 by Level 1
  • 1663 Views
  • 4 replies
  • 0 Helpful votes

Hello to all, There is one answer right, i marked my choices in green because i dont sure. please advise what is the correct answer and why. 1. which cisco technology is often used to create VPN tunnels between sites?a.catalyst switchb.cisco routersc...

Yanaqr by Level 1
  • 1378 Views
  • 2 replies
  • 0 Helpful votes

HiI have a FTD with one Outside interface and a Interface on a MPLS network. By default, all traffic is passing the outside interface. Traffic to an other site is routet through a S2S VPN. Everthing works fine. But if the Internet goes down (also VPN...

fuhdan by Level 1
  • 1673 Views
  • 0 replies
  • 0 Helpful votes

 Hello Folks, I am running into an issue where I cannot touch / connect with any networks that are not directly connected to the ASA from the WAN interface. However, if I am connected through SSL VPN or connected to one of the networks hosted by the ...

dj0321 by Level 1
  • 1822 Views
  • 3 replies
  • 0 Helpful votes

We are planning to use PPPoE on FTD interface to connect to Internet. The IP we get is randomly assigned by service provider and may change periodically. Is there any way we may get the (PPPoE) IP change notification(& the new IP) in FMC every time i...

jc8780 by Level 1
  • 826 Views
  • 0 replies
  • 0 Helpful votes

Hello friens I hope  you are good.  People  I need to make a static Nat for both flow direction inside a VPN  Site to site.  This  is the  configuration nat (interface inside - interface outside) 1 source static A.A.A.A B.B.B.B destination static Z.Z...

I have two ASA 5508-x, running same software version and ASDM.  One has Firepower license but the other does not.Is it possible to create active/standby failover with these pair of ASA? Help. Thanks

wired_j by Level 1
  • 2330 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card