12-24-2013 12:08 AM - edited 03-11-2019 08:21 PM
Hello,
I would like to know if I can use management interface as firewalling interface like Outside, Inside and DMZ interfaces instead of just out of band interface.
I have a Cisco ASA.
Thanks a lot, best regards.
Solved! Go to Solution.
12-24-2013 03:15 AM
Hi,
Yes, it's possible and allow routing on the said interface. Just do a 'no management-only' command under management0/0.
Sent from Cisco Technical Support iPhone App
12-24-2013 05:05 AM
it depends on the model you have. The old models and 5585-X can do that, but not the newer X-generation:
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
12-24-2013 03:15 AM
Hi,
Yes, it's possible and allow routing on the said interface. Just do a 'no management-only' command under management0/0.
Sent from Cisco Technical Support iPhone App
12-24-2013 05:05 AM
it depends on the model you have. The old models and 5585-X can do that, but not the newer X-generation:
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
12-24-2013 07:09 AM
Thanks Johnlloyd and Karsten,
I'll configure management interface as a firewalling interface with 'no management-only' command because it is a old device.
Thanks a lot and happy new year.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: