Managment deploy configuration FMC.

[slonik220393]

Good day. I apologize for the stupid questions, but for some reason I cannot find the answer in the documentation. When making a change to FMC, data for the deployment to FTD is collected, in FMC you can see the configuration of which modules will be affected, but is it possible to cancel / discard the accumulated changes (in whole or in part), i.e. synchronize configuration on FMC with FTD, how could this be done in ASDM? Is it also possible to verify which commands will be sent to the FTD during the deployment of the new configuration? Those. you can see the transcription in the Deplyment History, but it will be in fact, but I would like to somehow get acquainted with this information before deployment, in ASDM it was possible.

[Francesco Molino · Accepted solution]

Hi

You can't use asdm.
On FMC, right now there are no options to see exactly what will be deployed nor a discard option.
You will see what type of config still be changed like access policies but not the exact rule.
This is coming in the coming version but still no discard option.
If you check on Cisco bug portal, there's still an enhancement bug open for these features.