Just want to check with you about memory utilization on the Asa 5510 ..
Free memory: 19%
Used Memory: 81%
Is this normal? Because we hade a problem this morning and the memory was at 100%..
Device Manager version 6.1(5) 57
Hardware: ASA5510-K8, 256 MB RAM, CPU Pentium 4 Celeron 1600 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash M50FW080 @ 0xffe00000, 1024KB
Any tips and tricks?
Open a TAC case as soon as you can so we can take the required outputs to decode what is going on, This is definetely not expected ( Because we hade a problem this morning and the memory was at 100%)
Well i don't think its a huge problem, I think it was a spanning tree issue on the switches..
But for now the mem utilization is at 81%..
Okay, good to know that,
Here are some facts about memory problems:
Here are some possible causes and resolutions for high memory utilization:
Thanks for the info,
I have one more question, now the ASA is working fine, but one thing is a little off, the dmz interface is not working the way it suppose to. Clients are not reaching the servers on the DMZ interface Maybe it has something to do with that we hade a failover firewall that was On before..But probably not..
Also Syslog Messages in the ASDM, i see a bunch of
DENY ICMP revers path check from x.x.xx to x.x.x.x on interface dmz
DENY ICMP revers path check from x.x.xx to x.x.x.x on interface outside