Module sfr did not respond to session request.

[seckka21]

Hello 

I have an ASA  5525-X versio 9.8 and i am trying to install firepower module 6.2.2 but i am still having this error.

Module sfr did not respond to session request.

Here you are the show version and another command.

[balaji.bandi]

Logs i can see was yesterday one.

<--- More ---> Status: Mapping host 0x2aab78600000 to VM with size 67108864
<--- More ---> Warning: vlan 0 is not connected to host network

what happends after this message ?

If you looking to resolve the issue, please do follow the steps  as guided earlier do make all Logs  and post here. the video is well explained and documented.

( if you getting still same error  it might have corrupted  SSD - need to raise an TAC to RMA).

[seckka21]

Hello 

when i use the ASA for the first time sfr 6.2.2 was installed but when i try to  open a session console it always show System initialization in progress thatis why i uninstall the sfr module to reimage it.I have follow the documentation in cisco site.After executing the recover boot command i noticed there have been many line of log .But i have waited more than four hours and i can't open session.I decided to stop the recovery and restart the process .Since i began now i have few logs and the module behave the sames.I think the ssd has a problem.

[balaji.bandi]

.I think the ssd has a problem.

if this is conclude need to raise an TAC for RMA and re-image.

[seckka21]

Hi 

i have executed these commands before sw-module module sfr recover boot

i have more logs and the console always show this error below.

debug sfr error
debug sfr events
debug sfr messages
debug cplane
debug module-boot

cp_update_connection: Error updating connection_id 0
ciscoasa(config)#
cp_connect: Error - cp_connect() returned -1
cp_check_connection: handle -1, conflicts with connection 1 (-1)
cp_check_connection: handle -1, conflicts with connection 2 (-1)
cp_check_connection: handle -1, conflicts with connection 3 (-1)
cp_update_connection: Error updating connection_id 0
cp_connect: Error - cp_connect() returned -1
cp_check_connection: handle -1, conflicts with connection 1 (-1)
cp_check_connection: handle -1, conflicts with connection 2 (-1)
cp_check_connection: handle -1, conflicts with connection 3 (-1)
cp_update_connection: Error updating connection_id 0
cp_connect: Error - cp_connect() returned -1
cp_check_connection: handle -1, conflicts with connection 1 (-1)
cp_check_connection: handle -1, conflicts with connection 2 (-1)
cp_check_connection: handle -1, conflicts with connection 3 (-1)
cp_update_connection: Error updating connection_id 0
cp_connect: Error - cp_connect() returned -1
cp_check_connection: handle -1, conflicts with connection 1 (-1)
cp_check_connection: handle -1, conflicts with connection 2 (-1)
cp_check_connection: handle -1, conflicts with connection 3 (-1)
cp_update_connection: Error updating connection_id 0
cp_connect: Error - cp_connect() returned -1
cp_check_connection: handle -1, conflicts with connection 1 (-1)
cp_check_connection: handle -1, conflicts with connection 2 (-1)

[seckka21]

Finally i have a solution.

Instead of installing  firepower version 6.2.2 i try 6.2.3 and it works .Thank you.

[balaji.bandi]

Nice and good to know you were able to resolve the issue.