03-30-2012 09:54 AM - edited 03-11-2019 03:49 PM
Just starting to learn about multiple context and and not sure about interfaces.
Do you have to use VLANs?
I tryed to setup an interface and the ip address command is not there, I am not using VLANs.
I did allocate an interface to the context.
03-30-2012 10:37 AM
Hi kcmusa108,
What are you talking about? ASA, FWSM?
To FWSM you need decide how it will work: routed or transparent mode;
You should also create the interfaces vlans at the system context;
After, you should change to the new context and then configure it.
If you choose transparent mode, you will be able to create BVI interfaces and if you choose routed mode, you can configure ip address at interface vlans.
Att,
Plínio Monteiro
03-30-2012 11:12 AM
Hi,
Please follow this configuration guide for multiple context on ASA, I am sure you would not have any issues after it:
Thanks,
Varun
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide