06-19-2015 11:53 AM - edited 03-11-2019 11:09 PM
Hello I need to setup an inbound nat rule using the following:
- inbound nat will be 168.97.45.6
- translation ip will be 209.165.201.3
- outside host 208.45.6.7
What would be the best way to create this rule?
Solved! Go to Solution.
06-23-2015 04:46 AM
Hi,
Yes , this is all that is needed. To verify if you have everything , you can run a packet tracer and see if allows the traffic:-
https://supportforums.cisco.com/document/29601/troubleshooting-access-problems-using-packet-tracer
Please select the reply as solution which you think answers your query.
Thanks and Regards,
Vibhor Amrodia
06-19-2015 07:31 PM
Hi,
You would have to create a Static NAT on the ASA device and as per the Outside host is connected it can be a single IP or anything on the internet which would be able to access this server from the outside
On the ASA 8.2 and before:-
static (inside,outside) 209.165.201.3 168.97.45.6
access-list inbound permit ip <any>(or host 208.45.6.7) host 209.165.201.3
On the ASA 8.3 + :-
object network obj-168.97.45.6
host 168.97.45.6
nat (inside,outside) static 209.165.201.3
access-list inbound permit ip <any>(or host 208.45.6.7) host 168.97.45.6
Thanks and Regards,
Vibhor Amrodia
06-22-2015 06:44 AM
Thanks Vibhor,
This is all that should be needed ... correct :)
I appreciate your help with this. I no that there was a lot of changes with NAT
Regards
James
06-23-2015 04:46 AM
Hi,
Yes , this is all that is needed. To verify if you have everything , you can run a packet tracer and see if allows the traffic:-
https://supportforums.cisco.com/document/29601/troubleshooting-access-problems-using-packet-tracer
Please select the reply as solution which you think answers your query.
Thanks and Regards,
Vibhor Amrodia
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: