02-05-2020 05:28 AM
Hi,
I have tried to find information about licensing on new N520 with no success.
Could someone clarify which ports are enabled by default and what is the difference between Metro Access and IP Access tech packages?
Thanks in advance
02-05-2020 02:32 PM
Here is some documentation on the licensing. This is for the ASR 920 router but the feature set should be the same for the NCS520. It is quite odd that no documentation for the NCS520 actually references these licenses.
● Metro Access License: Offers advanced quality of service (QoS), Carrier Ethernet Layer 2 features, Synchronous Ethernet (SyncE), and Ethernet operations, administration, and maintenance (OAM) capabilities.
● Metro IP Access License: Offers all capabilities of the Metro Access license with the addition of IEEE 1588-2008 Ordinary Clock and Transparent Clock, Bidirectional Forwarding Detection (BFD), Layer 3 features for advanced IP routing protocols, multi-VPN routing, and Layer 3 Multicast and Forwarding Customer Edge (multi-VRF CE) capabilities.
● Advanced Metro IP Access License: Adds the following capabilities to the Metro IP Services license: Multiprotocol Label Switching Transport Profile (MPLS-TP); MPLS, Ethernet over MPLS (EoMPLS), Circuit Emulation Service over Packet Switched Network (CESoPSN), and Structure Agnostic TDM over Packet (SAToP) pseudowires; Multirouter Automatic Protection Switching (MR-APS); Multichassis Link Aggregation and Control Protocol (mLACP); MPLS traffic engineering (MPLS TE); MPLS Fast Reroute (MPLS FRR); and MPLS VPN support.
This link has some info on the ports with default mode and some information on license requirements to unlock higher speed modes.
08-27-2020 10:27 AM
Do any of these licenses support NAT?
09-01-2020 11:24 AM
This device is not for NAT. No any useful commands.
03-28-2020 09:24 AM
License Level: metroipaccess License Type: Permanent Next reload license Level: metroipaccess Smart Licensing Status: Smart Licensing is DISABLED cisco N520-20G4Z-A (NXP LS1043A) processor (revision 1.0 GHz) with 854785K/6147K bytes of memory. sh license Index 1 Feature: metroipaccess Period left: Life time License Type: Permanent License State: Active, In Use License Count: 1/1/0 (Active/In-use/Violation) License Priority: Medium Index 2 Feature: metroaccess Period left: Not Activated License Type: Evaluation License State: Active, Not in Use, EULA not accepted License Count: Non-Counted License Priority: None Index 3 Feature: 1GEupgradelicense Period left: Life time License Type: Permanent License State: Active, In Use License Count: 2/2/0 (Active/In-use/Violation) License Priority: Medium Index 4 Feature: 10GEupgradelicense Period left: Life time License Type: Permanent License State: Active, In Use License Count: 1/1/0 (Active/In-use/Violation) License Priority: Medium sh license feature Feature name Enforcement Evaluation Subscription Enabled RightToUse metroipaccess no yes no yes no metroaccess no yes no no no 1GEupgradelicense yes no no yes no 10GEupgradelicense yes no no yes no
Index 3 Feature: 1GEupgradelicense
License Count: 2/2/0 (Active/In-use/Violation)
--- Make active: 16x1GE ports (SFP)
Index 4 Feature: 10GEupgradelicense
License Count: 1/1/0 (Active/In-use/Violation)
--- Make active: 2x10GE ports (SFP)
Only 4x1GE Ports (RJ45 Copper) allowed by default without License.
09-15-2020 08:43 AM
somebody knows if this NCS520 supports MPLS? if so, wich license is need it? what i see in CCW, N520 dont have the option of Adv Metro IP access License that ASR920 has..do you know if it is supported?
11-18-2020 04:31 AM
No. These boxes barely forward packets -- strongly advise not to think about MPLS on them.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide