Hi, imagine both interfaces below are up.
I am configuring an ASA for the first time.
What am I missing to ping from my own MYASA to the interfaces below?
!
interface GigabitEthernet0/0
nameif internal
security-level 100
ip address 1.1.1.1 255.255.255.0
MYASA# sh run int g0/2
!
interface GigabitEthernet0/2
nameif dmztest
security-level 0
ip address 2.2.2.2 255.255.255.0
MYASA# ping 1.1.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 1.1.1.1, timeout is 2 seconds:
No route to host 1.1.1.1
Success rate is 0 percent (0/1)
MYASA# ping 2.2.2.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 2.2.2.2, timeout is 2 seconds:
No route to host 2.2.2.2
Success rate is 0 percent (0/1)
MYASA#