06-17-2015 04:04 AM - edited 03-11-2019 11:08 PM
Colleagues, good afternoon.
Prompt please who knows. Cisco ASA 5510 supports the creation of clusters of ME, if so, in this case the load balancing?
And the second question when setting FAILOVER ACTIVE / ACTIVE how to configure load balancing, is there any tools?
06-18-2015 12:32 AM
Hi,
I am guessing that your first query seems to be related to the Port Channels. It is supported on the ASA device. Yes , it will be load balancing the traffic on the basis of 5 Tupple
Refer:-
http://www.cisco.com/c/en/us/td/docs/security/asa/asa84/configuration/guide/asa_84_cli_config/interface_start.html
As per the 2nd query , Load Balancing would be on the basis of routing traffic between the contexts in different Failover groups as we can change the state (Active or Standby) of these groups on the ASA units which would load balance the traffic.
Refer:-
http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/91336-pix-activeactive-config.html
Thanks and Regards,
Vibhor Amrodia
06-18-2015 12:37 AM
Thank you!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide