03-16-2005 11:49 PM - edited 02-21-2020 12:01 AM
Hi All
Can any one confirm that wether i can enable NTP in pix and have ntp association with ntp master in my network which is also a cisco box configured as ntp master
Regards
Parthiban
03-17-2005 02:26 AM
Hi parthiban
yeah.. u can run NTP in cisco firwall OS more than 6.2.. NTP was introduced in 6.2 IOS.. once you have 6.2, u can configure NTP server IP address and md5 secret and get connected to a NTP server.
example config:
ntp authentication-key 1 md5 ********
ntp trusted-key 1
ntp server 10.0.6.5 key 1 source inside
see if this URL helps you...
rate replies if found useful..
Raj
03-17-2005 10:48 PM
Hi Raj
Thanks for the response.
Could you please tell me where in i have pix in failover and the ntp server is on the inside interface of my firewalls. Here how can i have a ipsec tunnel between my failover boxes. I hope whatever the config i have on my primary active will sync with secondary standby. Should i go to two boxes sep and enable ipsec tunnel for ntp to work with pix.
Please explanin
Regards
Parthiban
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide