Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am trying to export my passed/failed authentication log to MS-EXCEL . Since my log in acs is huge MS-EXCEL has a restriction on the number of rows and columns. How do i delete the old logs and have the logs between specified dates.Or is there any...
HiI have 1751 router with fastethernet assigned an ip of 172.20.7.88/22. Other pcs are on same subnet. I could not ping any of the host or my gateway 172.20.4.1/22. My fastethernet is up and lineprotocol is up. When I check the arp cache i see a inco...
Hi Iam using cisco aironet 1300 as a wireless bridge configured as a root and non root to connect various remote location of my city to my data center. At my data center i have few 1300 wireless bridge configured as root. All my remote location radio...
i am trying to access the xmanager from a windows pc on outside interface to a solaris server on the inside interface of the pix. I could not establish the xmanager session and i get error message xdmcp connection failed the pix iam using is 515 with...
HelloI have a multilink bundle which will be the path used for my primary tunnel. I need to set mpls exp bit for qos (bandwidth reservation for specific traffic class) Now iam applying my service policy applied on the multilink interface.If enable my...
HiI hve given try with ext ping also. This is the only interface up and connected. All other int like wan interface and bri0/0 are kept shutdown. Will the router try to route the packet on a shutdown interface. Iam not sure . Guide me if Iam wrong.Th...
No 172.20.4.1 is the gateway for me to go to internet which is another router. All pcs use this as a gateway and able to ping the gateway. Iam just trying to ping the same gateway from my router with fa assigned an ip in same subnet say 172.20.7.88. ...
Hi RajThanks for the response. Could you please tell me where in i have pix in failover and the ntp server is on the inside interface of my firewalls. Here how can i have a ipsec tunnel between my failover boxes. I hope whatever the config i have on ...
Hi RajThanks for your response. I have enabled the post fast already for all the ports directly connected to pix. but trunking is also off, I have given switchport mode access in all the ports. what do u mean by channeling on these ports.Further my ...
Thanks Lincoln for your reply. I tried all options. But can u tell me what should be the settings on my xp side. ie what authentication type should i say on the xp side. I have given the preshared key and trying but not able to establish the tunnel.
