09-06-2006 11:23 AM - edited 02-21-2020 01:09 AM
I have a config I have been working on to track an interface on a WAN router that maintain Point to Point interfaces to various sites. Does anyone know if it is possible to track a DLCI. I know it is a virtual ID, but maybe route tracking? What I need to do is to set up a PIX to redirect LAN traffic to a VPN. Currently only internet traffic is Passing through the PIX.
09-06-2006 09:52 PM
i'm really not sure of your requirement... can you brief a little more on what you exactly need ???
09-07-2006 05:56 AM
Well, we have about 15 sites around the country, Each has a FR shot and a separate VPN. Internet traffic goes through the PIX, regular traffic through the Sprint FR cloud. Each VPN has its different provider. We have Altigen for Voice that runs over the FR so QOS is implemented. I wish to track the interface on the FR side and when it goes down have the PIX, which all the traffic defaults to forward the traffic to the VPN. The voice will be touch and go, but that is ok, because we have POTS as well.
09-07-2006 11:09 AM
Sounds like you might want to create a gre tunnel and pass some sort of dynamic routing protocol that will take care of the redirection of traffic. Can you post a diagram of what your setup looks like?
09-07-2006 01:01 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide