Network Security

Engage with peers and experts on network security topics such as Secure Firewall Threat Defense, Adaptive Security Appliance, Secure Firewall Management Center, and Security Cloud Control.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Join

 
Labels

Forum Posts

Hi,I request your help for below.We have gotten two old PIX 520 firewalls in our office. We intend to do following:1. Each firewall has 6 interfaces. 1st one would go for Internet. Can we configure remaining 5 interfaces for five different networks. ...

3shoolgmail by • Community Member
  • 836 Views
  • 2 replies
  • 0 Helpful votes

Even if there are no reports pending to be generated the REPORT RUNNING icon blinks. This stops from Compacting the database with message that DATABASE IS IN USE TRY LATER. How to stop the report running blink, so that compact DB works.

I have two PIX 525s in FO config. Suddently the PIX stopped routing packets. All interfaces were up, but I couldn't access them, nor could I access the console. I recycled them, and viola everything started working again. Has anyone run into this bef...

I have VPN access configured and working on the corp. PIX (525). I have a PIX 506 at my home office. The VPN client connects to the Corp. PIX without a problem, however I don't have any access to the corp network. It's as if my 506 is blocking traffi...

mikef by • Community Member
  • 431 Views
  • 1 replies
  • 0 Helpful votes

how does one go about monitoring the individual ipsec tunnel status on a Cisco router? We have a router as our vpn gateway, and it has about 20 ipsec tunnels of it. It would be nice to be able to gather info for each connection. I don't know what my ...

mjsully by • Level 5
  • 668 Views
  • 1 replies
  • 0 Helpful votes

HI Guy,i have one PIX 515 firewall appliance, it's already used. but i don;t have the password. i tried to recovery the password throu console.my pix interface's are not getting initialize.i have pasted the copy of error message""""Use BREAK or ESC t...

Hi to All,Please let me know whether the Ipv6Address is accepted as a data type of "ASN AND SMIV2" data type or it is proposed one.If it is a SMIv2 data type, please let me know the tag value of the same.Thanks in advanceThanksRavi

smartravi by • Community Member
  • 642 Views
  • 1 replies
  • 0 Helpful votes

hello!i have pix 515e wich protect my dmz and corporate network.i have ipsec vpn lan2lan connections to outside officesin my network i use 15 exchange 2003 mail servers and 1 sendmail mail gateway in dmz. one exchange 2003 server is inside net wich c...

The LAN ports (1-4) appears to lock-up. Cannot ping or get arp requests from the LAN side of the firewall. Also the activity lights on the LAN side will stay hard light even when nothing is plugged in. On responses to power plug off/on. Code 6.3 (5)....

jbelk by • Community Member
  • 894 Views
  • 4 replies
  • 0 Helpful votes

I have a pair of PIX 515e's in a failover configuration using the failover cable. I have simulated a power failure on the primary device and the secondary device kicks in straight away - exactly as it is supposed to!My question is, if the primary dev...

Hi , this is quite a general question . I'm wondering about ASA55xx vs PIX . What are the differences ? Is PIX phasing-out replaced by ASA ? thanksStefano

scolombo by • Cisco Employee
  • 643 Views
  • 1 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card