OSPF E2 Default route in FTD

[great.mathmatician11]

Hi, 

I have a question if someone can help me with that please, I have FTD configured in Active standby and managed by FMC. These FTDs are going in to an upstream nexus switch. I am using RFC1918 addresses between the outside interface of FTD and SVI on the switch. I have run OSPF between the SVI and the outside interface which is working, the neighbourship comes up, switch and FTD are learning the OSPF routes from each other, but the problem is i have issued a command default information originate always on nexus and FTD is not taking a default route in its routing table. In principle it should work but is there any limitation on the FTD?

Your help on this would be highly appreciated. 

[MHM Cisco World]

Friend you already config defualt information under ftd ospf' so sure the router freezes not accept one receive from nsk.

Or this is typo?

MHM

[great.mathmatician11]

no it was not a type, i switched it on for testing and i switched it off after you highlighted this. But it did not make a difference, I power cycle my FTDs and now it is working, it is getting the default route now thanks for help and bearing up with me

[MHM Cisco World · Accepted solution]

You are so so welcome'

Glad issue  is solved finally.

Now clean your config' any unnecessary steps we add through troubleshooting remove it.

Have a nice day 

MHM