cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
811
Views
0
Helpful
4
Replies

Outside interface on Multiple context ASA

mahesh18
Level 6
Level 6

Hi Everyone,

Need to confirm below

If we have ASA in multi context mode and it has only single interface say gi2 that is shared between 2 contexts and its subinterfaces have different

IP address then we can confirm that this is the outside interface of the ASA as a whole?

Regards

Mahesh

2 Accepted Solutions

Accepted Solutions

Jouni Forss
VIP Alumni
VIP Alumni

Hi,

If the ASA only is connected through the physical interface Gi0/2 to the next device and its divided into subinterfaces then it would seem that one of those interfaces is used for outside connectivity.

Judging by what you say the ASA has a single Trunk link to some neighbor device and subinterfaces are used to handle "inside" , "dmz" , "outside" and all other kinds of interfaces for the actual Security Contexts.

Without seeing any configurations I dont know if there is anything else that can be said of the setup.

- Jouni

View solution in original post

Hi,

Well it depends.

I think by default the ASA is set to have same MAC address for each subinterface of a single physical interface.

To my understanding this is changed by setting the "mac-address auto" in the System Context configuration after which the ASA generates MAC addresses for the interfaces. The default setting is, as I said, "no mac-address auto".

Or you can even set the interfaces MAC address under the interface configuration mode.

Here is a link to a command reference which explains the command use

http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/m.html#wp2043127

- Jouni

View solution in original post

4 Replies 4

Jouni Forss
VIP Alumni
VIP Alumni

Hi,

If the ASA only is connected through the physical interface Gi0/2 to the next device and its divided into subinterfaces then it would seem that one of those interfaces is used for outside connectivity.

Judging by what you say the ASA has a single Trunk link to some neighbor device and subinterfaces are used to handle "inside" , "dmz" , "outside" and all other kinds of interfaces for the actual Security Contexts.

Without seeing any configurations I dont know if there is anything else that can be said of the setup.

- Jouni

Hi Jouni,

For current setup seems gi0/2 is outside int of ASA.

Also the shared interface which is Gi0/2  has different mac address for each context i mean to say

context admin

int gi0/2.3  has say mac of 1234

context x 

int gi0/2.5  has say mac of 6789

So this is default behaviour?

Regards

MAhesh

Hi,

Well it depends.

I think by default the ASA is set to have same MAC address for each subinterface of a single physical interface.

To my understanding this is changed by setting the "mac-address auto" in the System Context configuration after which the ASA generates MAC addresses for the interfaces. The default setting is, as I said, "no mac-address auto".

Or you can even set the interfaces MAC address under the interface configuration mode.

Here is a link to a command reference which explains the command use

http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/m.html#wp2043127

- Jouni

Hi Jouni,

Many thanks

Best reagrds

Mahesh

Review Cisco Networking for a $25 gift card