cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1018
Views
0
Helpful
1
Replies

Pacbell DSL & PIX 501- what a mess!!

rgrcommo
Level 1
Level 1

I have 5 static address w/ Pacbell DSL. I am an experienced PIX user but I think that Im loosing my mind here with some issues I am having.

PIX 501 is Version 6.1(2).

Overview: I have 5 users on the inside interface of the PIX. They just surf the web / email etc..

- Issues

I am seeing these users timing out all the time and when they leave the computer for a certian amount of time they can not connect - they can ping the inside interface of the PIX though. I can not ping the gateway either.

Now 1 step back, when they could access the net from there box I could ping the gateway address.

I have nat 1 going back to the inside interface for all to use. I have global 1 outside using two different IPs

Everyting is set right.. I checked the timeout w/ xlate, arp. conn they are at the default.

I am beg. to think ths dam ver of IOS is buggy.. Any one have anoth ideas..?

1 Reply 1

wdrootz
Level 4
Level 4

Well if you have only two addresses in your global pool shared by five users that will present a problem. You might consider just using one IP address (enabling PAT) and see if connectivity improves.

Review Cisco Networking for a $25 gift card